Handguard Hitch for FasstCo Flexx Handguards

The new BRP Handguard Hitch for Fasstco Flexx Handguard provides a moveable inner mount point that works well with Cycra ProBend or Enduro Engineering Evolution handguards.

The newly designed BRP M10 Flexx Mounts uses a 10mm bolt that threads directly into the steel pivot pin on the Fasst Company Flexx Bars. The BRP M10 Flexx Mounts will allow you to mount most popular style aluminum hand guards to your Fasst Company Flexx Bars. The BRP Flexx Mounts were designed exclusively for Cycra Probend handguardsand in most cases can be used with other aftermarket handguards with little modifications. The Flexx Mounts are manufactured from billet 6061 T-6 aluminum to our high quality standards of fit and finish and feature our signature black anodize with laser etched BRP logo.


SPECIAL NOTES:  This new style handguard mount requires the Flexx Bars to have the M10 Threaded Steel Pivot Pin.

Handguards are made as a universal product and every setup is different. There are several variables that influence the fit of these type of hand guards: such as bar width, height, position etc. When installing new handguards it's usually best to fit the handguards up and float them in before you tighten any bolts. In some cases it may be necessary to slightly bend the handguard to fit correctly especially if your running a very narrow handlebar.
 



Handguard Hitch for FasstCo Flexx Handlebar
BRP M10 Flexx mount designed specifically to mount handguards on the Flexx Handlebar System.
FA-HGM100
$69.99
 
 



Cycra and Enduro Engineering Handguards for use with BRP Handguard Hitch



Alloy Probend Handguard Pack
Includes Alloy Probend Handguard Bars w/Bumpers, Enduro Shields, and Powergrip bar-end mounting hardware. Specific bar mounts sold separately. Dimensions: 6 1/8" tall x 9 3/4" wide. No drilling required. CY-7500

Go to Cycra Alloy Probend Handguard Pack



Evolution Replacement Handguard Bars - Black or Silver
Includes left and right Bars w/bar-end hardware.
EE-505100 / EE-505200

Go to Enduro Engineering Evolution Replacement Handguard Bars




EVO2 Plastic Outer Mount Roost Deflectors
Easy Installation with two bolts on the front with Front mounting plate.
Colors:  White, Blue, Black, Orange, Red, Yellow and Green
Deflector Dimensions:  5 1/2" tall x 9 1/2" wide. No drilling required.
EE-5122x

Go to Enduro Engineering Evolution EVO2 Plastic Outer Mount Roost Deflectors

Grip Heaters
For use on any motorcycle or ATV with a battery and charging system or a lighting coil.
 
Go to Grip Heaters Page

Giant Loop / Fastway-Pro Moto Billet Handguard Shields
Install over rigid handguards/deflectors and heated grips for the ultimate protection against the elements.


Go to Handguard Shields Page

Bar End Mount Kits
Fastway Threaded Bar End Insert Conversion Kit
Handguard Bar End Set - fit most alloy or steel handlebars and Renthal Twinwalls
G2 Nylon Bar End Mount Kit


Go to Other Bar End
Mount Kits

G2 Billet Grip Protector Kit
For aluminum handlebars only.
G2-60350
 
Go to G2
Billet Grip Protectors